This article shows you, how you can define values for visits based on accessed pages. For doing so, different numeric values are assigned to single pages.
As a result you get another interesting key figure besides the classic KPIs like Bounce Rate and Conversion Rate, that represents information about the quality of the visit.
- Step 1: Setting up a content group
- Step 2: Submitting data
- Step 3: Setting up a formula
- Step 4: Analysis and usage
Assign a numeric value to each page. It shows the importance of the page for reaching a website goal. Thus, higher values are assigned to more important pages.
For a shop the values could look like this:
A visit in which 2 products have been viewed and a registration for the newsletter was made would have a visit value of 92. A visit in which none of the depicted pages has been accesses would have no visit value.
The numeric values can be configured for each page via content groups.
Step 1: Setting up a content group
You can set up content groups at "Webtrekk Q3 > Configuration> Categories > Content Groups".
Use the following setup:
Please note: The Category ID can be chosen arbitrarily, as we submit the data via import.
Step 2: Submitting data
Now the visit value can be imported for each page. This is possible via Excel, JSON, SOAP and Datafeed. The following example shows the Excel import.
- Choose "Import and Export" in the configuration section of the content group.
Choose "Export > Export" in the shown layer.
The data is exported into an Excel table. The corresponding pages can be assigned to the content group "Visit Value" in this table. Placeholders can also be used for import. In this example the value 1 is assigned to all pages, that end with "productview".
Now you can import the updated Excel table via "Import".
Please note, that it usually takes about 1 hour until the import is processed.
If other logins should see the content group "Visit Value", too, you have to unlock these for them in the user management ("Webtrekk Q3 > Configuration > User Management").
Step 3: Setting up a formula
The Visit Value is available as 2 metrics
- Visit Value: contains the summed value over all pages.
- Qty Visit Value: depicts how often the Visit Value has been tracked.
For a meaningful analysis you have to define a formula, that shows the average visit value per visit.
For doing so, click on "Webtrekk Q3 > Configuration > Custom Formulas > New Formula".
Step 4: Analysis and usage
The visit value can now be used as metric in all analyses. Often this is done in campaign analyses.